Door and gate control guides: error codes and troubleshooting
An industrial door stops, a gate will not close or a control LED flashes? Identify the control or operator on its rating plate and open the corresponding guide. Each guide explains the messages and helps you prepare useful information for diagnosis and spare-part selection.

GfA TS 971 error codes and troubleshooting
46 error codes with possible causes, checks and spare-part links.
Open guide ›
Marantec CS 320 error codes and LED signals
LCD messages, LED signals and the control fault memory.
Open guide ›
Sommer twist M troubleshooting and LED indicators
LED indicators, radio faults and swing-gate troubleshooting.
Open guide ›
Hörmann A445 error codes and troubleshooting
Fault numbers, safety circuits and the industrial door control fault memory.
Open guide ›
FEIG TST FUZ-2Cx error codes and troubleshooting
F codes for movement, safety circuits, inverter and position sensing.
Open guide ›How to identify the right fault
- Read the manufacturer, model and variant from the rating plate. For Marantec, check whether the unit is a CS 320 or CS 320 FU.
- Record the complete code, display text or LED pattern. Note whether the fault occurs when opening, closing or stationary.
- Use the guide for that model. Repeated faults and stored events help the service technician identify the cause.
Choosing a replacement part
Compare the model, part number, supply voltage and control version before ordering a replacement board or operator. The safety-edge technology, photocell interface and encoder must match the installation. A fault code can have several causes, so inspection should precede replacement.
Work on the control, operator and safety devices must be carried out by qualified personnel. Isolate the supply and secure against restarting before work. Follow the manufacturer’s instructions, including battery isolation and capacitor discharge times where applicable. Stop using a system with faulty safety devices or uncontrolled movement.